Location based wifi

[KentG]

Hi!

Am I just a thick **bleep** or is it selfexplanatory how to use location based wifi?

Are you meant to have the Wi-Fi button ON or OFF when you're using location based wifi or is it meant to go on automatically when you are in the range of a certain wifi router? It states that it should "switch it on" whenever a configured network is within range but it doesn't.

If it is meant to go on automatically when you are within in range of a certain network, how did it get there in the first place? Yes, I know, stupid question. You have to switch Wi-Fi on initially and tell the Z2 that this is a network that I want you to connect to.

Anyway, perhaps some wizard can share some thoughts on this one...

Regards

[MrNutt]

I just tediously have to go programs/settings/wifi then select which of my three routers have the best signal.

I'd be happy with a home page shortcut key tbh!

[_alexdon_]

The wifi should turn on automatically when in range of those networks you have.Doesn't it happen?Do you use stamina too?

[KentG]

Yup. I am using Stamina mode. 

[_alexdon_ · Accepted solution]

Try to disable stamina and see how it goes.Also,in wifi-advanced,there is an option scanning always available.

[hedrox87]

Leave it ON when using Wi-Fi and forget when going out.. the system will turn it OFF automatically.
If you wanna go back to Wi-Fi You need to turn the screen ON, cause Stamina mode is blocking any network operations.
Unlock it for 3 - 5 sec till the wi-fi logo apears and you good to go.

[KentG]

Aaahhh.

Switched location based Wifi off and on and now it works.

Thanx guys

[_alexdon_]

Good to know.