Xperia Z3 back cover elevated itself

[Pz3004]

So I have been using my Z3 for about a month now, I recently noticed that my phone doesn't lay flat on the ground, it wobbles a little, then it starts to worry me, under close inspection, the back panel between the power button and the microSD card slot was elevated up, I am really concerned about it, is it because the overheating of the phone? The adhesive is melted by the overheating of the phone? I am scared that the phone will loss its waterproof ability…

[Uliwooly]

You can't overheat the phone, if it gets too hot, it will turn off

[Phy]

Yeah, best to contact Sony Xperia Support.
http://support.sonymobile.com/global-en/contactUs/

[dandy63]

Hi, a few similar posts regarding the same issue on the forum.....as mentioned contact your local Xperia Care or if you can take it into your place of purchase BUT do not let it near water in the meantime :smileysmileywink:

[Curnow1]

Question from me, did you leave it on the sun or the heater or near a hot place? If yes and it was 30 mins - 1 hour the adhesive could melt but you cant overheat the phone it turns off at 45C-50C

[Pz3004]

no, none of them, i'll always avoid my phone from getting direct contact of the sunlight or any heat source 

[Curnow1]

Might be the battery? Ive seen a thread about thr back coming off because of the battery. Anyways contact Sony or the place where you bought the phone

[Curnow1]

Hey so i just now looked at the photo because it was published by moss and yes it is the back cover but are you using a case or skin for the phone? I see a circle near the camera and flash. Anyone else sees that?

[Curnow1]

Mods *

[dandy63]

---

@Curnow1 wrote:
 I see a circle near the camera and flash. Anyone else sees that?

---

Hi, cant see any 'circle' ..........:smileyconfused: